KRUUSE Infusion set with Y-injection site 20drops/ml 30 pk

KRUUSE Infusion set with Y-injection site 20drops/ml 30 pkKRUUSE I. V. Infusion set featuring an air vent and a Y injection site, with a drop rate of 20 drops ml, available in packs of 30. This standard infusion set is designed for gravity use. 1) Secure the regulating clamp and the air vent cap. 2) Take off the protective cap from the spike and insert it into the fluid container to its full extent, ensuring the sterility of the product is maintained. 3) Open the air vent cap and gently squeeze the drip

KRUUSE I.V. Infusion set featuring an air vent and a Y injection site, with a drop rate of 20 drops/ml, available in packs of 30. This standard infusion set is designed for gravity use. 1) Secure the regulating clamp and the air vent cap. 2) Take off the protective cap from the spike and insert it into the fluid container to its full extent, ensuring the sterility of the product is maintained. 3) Open the air vent cap and gently squeeze the drip chamber until it fills to about half its capacity. 4) Remove the protector cap at the tube's end (again, being cautious not to compromise sterility), then open the regulating clamp to allow the fluid to replace all air in the tubing. Make sure to close the clamp securely. 5) Carry out the vein puncture following standard clinical procedures and let blood fill the needle/I.V. catheter. Attach (screw on) the tube to the needle/catheter and gradually open the regulating clamp to control the fluid flow. Please note: Avoid over-hydrating the patient and do not leave patients unattended during fluid therapy. Close the air vent when infusion therapy is temporarily halted.
Expires on 28 May 2030